How do you put a Bucktail stinger on a hook?

1:3211:38Tying Series: Bucktail Jig, Stinger Hook - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo now I have the tail end of the line on the bottom of this hook shank and then I have the the endMoreSo now I have the tail end of the line on the bottom of this hook shank and then I have the the end of the line on top of the hook shank in between my fingers.

How do you tie a stinger on a walleye?

2:573:46Pre-Tie Stinger Hooks Before You Are On The Water - YouTubeYouTubeStart of suggested clipEnd of suggested clipYour hook right through the loop that you made and then it will cinch up nice and tight you want toMoreYour hook right through the loop that you made and then it will cinch up nice and tight you want to pull on kind of both ends of it and then clip the tail end and slide it up towards the front.

How do you rig a stinger?

0:523:49Stinger Hook Rigging - Walleye Fishing Tips With Ian Jones YouTubeStart of suggested clipEnd of suggested clipSo to start get your needle get your stinger these are the longer ones with the clasp on the frontMoreSo to start get your needle get your stinger these are the longer ones with the clasp on the front so these dont go over the hook these actually will hook over the eyelet of the jig.

How do you tie a Bucktail knot?

6:2415:23How To Tie a Bucktail Jig (and all of the bucktail tying materials)YouTubeStart of suggested clipEnd of suggested clipSide. So were going to tie it on the base. And then further up so lets go ahead and do that soMoreSide. So were going to tie it on the base. And then further up so lets go ahead and do that so make sure they again just double-check the size.

How do you put a stinger on a jig?

0:051:05How To Add a Stinger Hook to Your Swimbait - YouTubeYouTube

How do you rig a trailer hook on a jig?

2:480:00How To Put A Trailer On A Jig - YouTubeYouTube

How long should a stinger hook be?

approximately three inches For most walleye fishing applications the stinger hook should be approximately three inches long. Shorter stinger hooks tend to position the treble hook too close to the jig hook to significantly improve the hooking ratio.

How do you use a bucktail jig?

23:4249:21JIGGING & FISHING BUCKTAILS - Jigs in Surf Bay & Inlet - YouTubeYouTube

What are stinger hooks used for?

The stinger hook is simply an extra hook added to the existing rig. There are stinger hooks readily available for sale but it is also possible for you to improvise – just tie the hook to a leader line and connect it to your rig, be it a live bait, jig, anything.

How do you rig a chunk on a jig?

2:005:23Jig Trailers How To Rig A Chunk Trailer On A Jig - YouTubeYouTube

Does a jig need a trailer?

Does my jig need a trailer bait? Most jigs are fished with a soft-plastic trailer bait attached to them. Soft Plastic “chunk” baits are specifically designed to be used as jig trailers, but traditional soft plastic craws, creatures, and swimbaits can also be used as jig trailers.

What makes a good stinger?

To play a stinger shot, you are going to use your longest iron while teeing the ball up in the middle of your stance. Playing from the middle of the stance is your best bet, as going too far back is going to make your swing too steep coming down. Also, you will need to choke down on the grip at address.

What is a chunk bait?

Chunking is one of the most effective ways to connect with big stripers and blues in the fall surf. Buy some bait, usually bunker, slice it into chunks to fit onto the hook, and cast it out in hopes that a trophy striper or blue will come along and make a quick snack of it.

Do you use weights with spinnerbaits?

Weights like 1/4oz and 3/8oz are ideal to keep the Spinnerbait higher up in the water column. If the bass are cruising the shallows in the spring or fall, these weights will allow you to keep the Spinnerbait above the grass, and will even give you the ability to “yo yo” them back to the boat.