The best way to connect it to a factory system is to tap into the stereos speaker outputs for the amps input signal. Youll need one for the amps input and the other for its output. These cables will act like a T-harness to connect your amp to the factory system.
How do you hook up a amp to a radio?
2:064:34How to install a car amplifier | Crutchfield DIY video - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe turn on wire is included in your amp wiring kit. Run these cables behind the dash to your stereoMoreThe turn on wire is included in your amp wiring kit. Run these cables behind the dash to your stereo. The turn on wire connects to a remote turn on lead in your stereos wiring harness.
How do you hook up an amp to a factory speaker?
10:5015:38Wiring a 2 or 4 channel amp to your stock speaker harness - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou have the option of using a second set of rcas from the rear RCA output to the rear RCA inputMoreYou have the option of using a second set of rcas from the rear RCA output to the rear RCA input you can also just use a single set of RCA.
How do you hook up an aftermarket speaker to an amp?
There are 3 basic ways to get a signal to your 4 channel amplifier:Connect speaker outputs to your amps speaker level inputs.Connect a line-level adapter to the radio then use RCA cables to the amp.Connect your radio to the amp using RCA cables directly.May 2, 2019
Can you connect a subwoofer to a factory stereo?
In techie terms: …it takes amplified speaker level signals and converts them into high quality preamp signals that can be fed into an amplifier. So now you know – its definitely possible to install a subwoofer and amplifier to your factory system, and still have it sounding good.
Do you need both RCA cables on an amp?
RCA cables (line-level connections) are the preferred way to connect a signal to your amp if you have that option. RCA jacks on the rear of a Pioneer head unit. This is the ideal way to connect your amplifiers signal inputs, if available. For a 4 channel amplifier, youll need 2 stereo RCA cables to do so.