How do you replace an ice maker supply line?
0:242:21How to Replace a Broken Refrigerator Water Line (Plumbing Tutorial YouTubeStart of suggested clipEnd of suggested clipAnd attach it to a saddle valve. And tighten it with an adjustable wrench. Open up the saddle valveMoreAnd attach it to a saddle valve. And tighten it with an adjustable wrench. Open up the saddle valve and let the water out to flush the line for about five minutes we dont want the stale taste.
What size is ice maker connector?
The tubing should have a diameter of 1/4-inch and can be copper line, braided steel line or plastic tubing. Many professionals prefer copper line, but plastic tubing is commonly sold as part of ice maker installation kits.
How do I install an ice maker outlet box?
0:131:14How To Install Ice Maker Outlet Boxes | SharkBite - YouTubeYouTubeStart of suggested clipEnd of suggested clipFirst attach the mounting brackets to the studs with screws or nails at your desired height. This isMoreFirst attach the mounting brackets to the studs with screws or nails at your desired height. This is typically 18 inches from the floor to the top of the outlet.
How do you replace an ice maker fill tube?
0:211:43Fill Tube (part 241796405) - Frigidaire Refrigerator Repair Help - YouTubeYouTube
How do you run an ice maker water line?
2:056:24How to Connect an Ice Maker Like a Pro | Ask This Old House - YouTubeYouTube
How do you thaw an ice maker fill tube?
Do one of the following depending on model and accessibility:Manually defrost the freezer for 4-6 hours by turning it off.Disable the freezer. Turn power to the unit off and use a steamer to aim steam at the ice maker assembly for 5-10 minutes. Fill tube is located on the back or side wall above the ice maker.
Why does my ice maker fill tube keep freezing up?
The ice maker fill tube can be accessed from the back of the refrigerator depending on the model. A refrigerator ice maker that freezes up can be caused by a frozen ice maker fill tube, faulty water inlet valve, too low freezer temperature setting, or a water filter that needs replacing.
How do I know if my ice solenoid is bad?
Touch the probes to each terminal on the solenoid coil (Fig. 4). The meter should read in the range of 200 to 500 ohms. If the meter needle does not move, the coil is bad.